Yueming MF20 - 3.1.1.3 Preparation; 3.1.2 Installation Steps; 3.1.2.1 Installing Fiber Laser Marking Cavity

21
3.1.1.3 Preparation
The preparations required before installation are as follows:
 Site
Please check if the site conditions and working environment for the laser equipment
comply with the requirements in Section 1.4 and the requirements of our company.
 Personnel
The equipment must be installed by our professional service personnel. If the customer
wants to install the machine, the installer must have received the full installation training
and have mastered the key points of laser equipment installation.
 Tools
The installation tools have been provided. In addition, the user should prepare some
installation and testing tools if necessary, such as screwdrivers, multimeter, etc.
 Others
The user needs to prepare the water, electricity, smoke exhaust channels, proofing
materials, computer and power outlets associated with the equipment.
3.1.2 Installation Steps
3.1.2.1 Installing Fiber Laser Marking Cavity
Take out the fiber marking cavity embedded in the control cabinet, and fix it on the
rotating plate of the base with four M5 hexagon socket screws, as shown in Fig. 3-3:
Note
 If any problem occurs after unpacking, please inform our
customer service or business personnel, or call the company
directly
 Do not attempt to handle without permission
Note
The customer shall accompany in the whole course when the customer service
personnel install the equipment. The installation and commissioning are part of
the training, and the user shall master.