Zapi ADPZP0CC - Page 26

Page - 26/36 ADPZP0CC - MHYRIO FLASH CONTROLLER - User Manual
Flow Chart showing how to make Program changes using Digital Console fitted
with Eprom CK ULTRA.
1) Opening Zapi Menu.
MHYRIO F ZAPI V0.0
48V 0A 00000
2) Press ENTER to go into the GENERAL MENU.
' % '
' ' '
3) The Display will show: PARAMETER CHANGE.
MAIN MENU
PARAMETER CHANGE
4) Press ENTER to go into the PARAMETER
CHANGE menu.
' % '
' ' '
5) The Display will show the first parameter.
MIN EV2
LEVEL = 4
6) Press ROLL UP and ROLL DOWN buttons until
desired parameter appears.
% ' '
% ' '
7) The names of the Parameters appear on the
Display.
MIN EV1
LEVEL = 5
8) When the desired Parameter appears, the
Display will show a Level Number that will be
between 0 and 9.
Press either SET UP or SET DOWN buttons to
change the Level value.
' ' %
' ' %
9) The Display will show the New Level.
MIN EV1
LEVEL = 6
10) When you are satisfied with the results of the
changes you have made, Press OUT.
' ' '
' % '
11) The Display asks: “ARE YOU SURE?”.
ARE YOU SURE?
YES=ENTER NO=OUT
12) Press ENTER to accept the changes, or press
OUT if you do not wish to accept the changes and
wish to make further modifications to the
parameters.
' % '
' ' '
' ' '
' % '
13) The Display will show: PARAMETER
CHANGE.
MAIN MENU
PARAMETER CHANGE