Page - 24/36 ADPZP0CC - MHYRIO FLASH CONTROLLER - User Manual
7.5 Description of parameters that may be programmed (parameter
change)
In addition to the Configuration, Parameter settings may be made by Zapi using
standard default settings, settings to Customer Specifications, or the customer
can make changes according to the application, using a Digital Console. During
the setting up procedure on the machine, the Console can remain connected to
the controller during travel. The Parameters can be modified in real time, during
operation. Pay attention to the polarity of the Console Connector.
CONNECTION OF THE CONSOLE TO THE CONTROLLER MUST BE MADE
WITH THE KEY SWITCH TURNED OFF.
The following Parameters can be modified:
1) MIN EV2
This parameter adjusts the minimum current of valve 2, if it is set as
proportional (see "set options menu").
2) MIN EV1
This parameter adjusts the minimum current of valve 1, if it is set as
proportional (see "set options menu").
3) MIN EV3
This parameter adjusts the minimum current of valve 3, if it is set as
proportional (see "set options menu").
4) MIN EV4
This parameter adjusts the minimum current of valve 4, if it is set as
proportional (see "set options menu").
5) MIN EV5
This parameter adjusts the minimum current of valve 5, if it is set as
proportional (see "set options menu").
6) MIN EV6
This parameter adjusts the minimum current of valve 6, if it is set as
proportional (see "set options menu").
7) MIN EV7
This parameter adjusts the minimum current of valve 7, if it is set as
proportional (see "set options menu").
8) MIN EV8
This parameter adjusts the minimum current of valve 8, if it is set as
proportional (see "set options menu").
9) MAX EV2
This parameter adjusts the maximum current of valve 2, if it is set as
proportional (see "set options menu").
10) MAX EV1
This parameter adjusts the maximum current of valve 1, if it is set as
proportional (see "set options menu").
11) MAX EV3
This parameter adjusts the maximum current of valve 3, if it is set as
proportional (see "set options menu").
12) MAX EV4
This parameter adjust the maximum current of valve 4, if it is set as
proportional (see "set options menu").
13) MAX EV5
This parameter adjusts the maximum current of valve 5, if it is set as
proportional (see "set options menu").
To Next Page
Loading...
