Page - 32/36 ADPZP0CC - MHYRIO FLASH CONTROLLER - User Manual
The table below indicates which parameter can be set to connect ZAPI product to
Console.
PARAMETER CONNECTED PRODUCT
1 SICOS
2 TRACTION CONTROLLER
5 PUMP CONTROLLER
6 EPS
9 MHYRIO FLASH
The range for this parameter is 0~32, but only above number are enabled. If
operator selects a not specified value, ZAPI Console reconnects the product
physically connected to Console. To have a confirmation of the product
connected, see the Opening ZAPI Menu.
To Next Page
Loading...
