Deva 5.8 and Deva 16 Owner’s Manual
Chapter 2
21
5. Press input you want change the signal phase inverted on.
You can invert the signal on both digital and analog inputs.
Figure 17 Sample Routing combinations
Setting the Number of Tracks Recorded
Once the routing is assigned, you have to enable the tracks to record. This is done in the Record Tracks
menu.
Main Menu > Deva Setup > Record Channels
Figure 18 Record Tracks menu
Any track that has an input assigned to it, displays blue in the Record Track menu. You can record any
combination of tracks, however you must have at least one track enabled for recording. Four buttons are
available which enable you to quickly setup the number of tracks recorded.
Perform the following to enable tracks for recording:
1. Press the button below the track.
An ’x’ is placed in the button indicating it is enabled for recording.
Once a track is enabled for recording, pressing the button again disables recording of that track.
Hint: Pressing the backspace button on the Deva keypad, then pressing the appropriate meter on the Home
Screen toggles the recording of that track.
Track Enabled
Track Disabled
To Next Page
Loading...
