Operations
Status Button
30
P1004197-001 Addendum to the SEH PS105-Z & PS102-Z User Guide 09/03/2008
for Zebra Printers
6. Once again, press and hold the Status button.
The LED’s blink simultaneously. After a few seconds, only the Activity LED (yellow)
blinks consistently.
7. Release the Status button.
8. Turn the printer off (O) and back on (l).
9. Press the status button for a short time to print a status page.
The status page may be used to check whether the parameters were successfully reset.
10. Once parameters are reset, reconnect the network cable to the SEH IPv6 PS device.
To Next Page
Loading...
