Zebra 105SL User Guide Addendum

35
Configuration
Control Panel
09/03/2008 Addendum to the SEH PS105-Z & PS102-Z User Guide P1004197-001
for Zebra Printers
Table 3 • Network Parameters for V60.16.x, R6x.16.x, or later Firmware
(105SL, Xi Series, RXi Series, Z4Mplus, Z6Mplus, and PAX4 Series)
Parameter
Function
WIRED PS CHECK?
1
View if the Printer Checks for a Wired Print Server at Bootup
This parameter, which serves the same function as the
^NB ZPL command,
tells if the printer searches for a wired print server at bootup.
Selections: YES, NO
Default Value: NO
LOAD LAN FROM?
1
View if IP Settings Are Loaded from the Printer or Print Server
This parameter, which serves the same function as the
^NP ZPL command,
tells if the printer uses IP settings from the printer or the print server at
bootup.
Selections: PRINTER, PRINTSERVER
Default Value: PRINTER
ACTIVE PRINTSRVR
2
View the Active Print Server
This menu item displays which print server is being used. This tells which
device’s settings such as IP protocol and IP address are being displayed
under those menu items.
Selections:
• WIRELESS indicates that the wireless device is active.
• EXTERNAL WIRED indicates that the external print server is active.
• NONE indicates that at least one of the network options is installed but
none of them are active. When NONE is shown for this menu item, the
device-specific items such as IP protocol and IP address will not display.
Default Value: NONE
RESET NETWORK
1,3
Reset the Wired or Wireless Network
Use this parameter to reinitialize the wireless radio card and the print server
(wired or wireless) when the wireless print server is running. This
parameter also causes any wireless radio card in the printer to reassociate to
the wireless network. (Same function as ZPL command ~WR. For more
specific details about ZPL commands, see ZPL II
®
Programming Guide
For x.14 Firmware and Above.)
1 Appears only when a wireless print server is installed.
2 Appears after the printer recognizes the existence of a print server (wired or wireless).
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.

Zebra 105SL Specifications

General

Print technology	Direct thermal
Display	LCD
Product color	Gray
Network ready	Yes
Dimensions (WxDxH)	283 x 495 x 394 mm
Standard interfaces	Parallel, Serial
Internal memory	6 MB
Maximum label width	115 mm
Maximum label length	0.991 m
Power requirements	90-264 VAC, 48-63 Hz

Weight and Dimensions

Depth	495 mm
Width	283 mm
Height	394 mm
Weight	29000 g