Zebra 105SL User Guide Addendum

37
Configuration
Control Panel
09/03/2008 Addendum to the SEH PS105-Z & PS102-Z User Guide P1004197-001
for Zebra Printers
RESET NETWORK
1,3
Reset the Wired or Wireless Network
Use this parameter to reinitialize the wireless radio card and the print server
(wired or wireless) when the wireless print server is running. This
parameter also causes any wireless radio card in the printer to reassociate to
the wireless network. (Same function as ZPL command ~WR. For more
specific details about ZPL commands, see ZPL II
®
Programming Guide
For x.14 Firmware and Above.)
1 Appears after the printer recognizes the existence of a print server (wired or wireless).
2 Appears only when a wireless print server is installed.
3 If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
Table 4 • Wireless Parameters for V53.16.x and R53.16.x Firmware
(ZM400, ZM600, RZ400, and RZ600 Printers) (Continued)
Parameter
Function

Zebra 105SL Specifications

General

Print technology	Direct thermal
Display	LCD
Product color	Gray
Network ready	Yes
Dimensions (WxDxH)	283 x 495 x 394 mm
Standard interfaces	Parallel, Serial
Internal memory	6 MB
Maximum label width	115 mm
Maximum label length	0.991 m
Power requirements	90-264 VAC, 48-63 Hz

Weight and Dimensions

Depth	495 mm
Width	283 mm
Height	394 mm
Weight	29000 g