78 Rev.A
DISASSEMBLY AND PREPARATION
NOTE:
1. Remove the ignition key and leave it outside the vehicle for the duration of installation.
2. wait for approximately 2-3 minutes until all vehicle systems have shut down completely before
starting the disassemble the original device.
3. Start to disassemble the original device.
4. Do not switch the ignition back on until all the points in the assembly manual have been
completed and the ZENEC system has been fully installed.
NOTE:
● Ensure that all connectors on the rear of the device have sufficient clearance and are not
kinked.
● Plug-in connections without a securing mechanism must also be secured with insulating
tape.
To Next Page
Loading...
