16
EXTERNAL EQUIPMENT SETUP
EXTERNAL EQUIPMENT SETUP
To prevent the equipment damage, never plug in any power cords until you have finished connecting all
equipment.
This part of EXTERNAL EQUIPMENT SETUP mainly use picture for LCD TV model.
HD RECEIVER SETUP
This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do
receive digital signals from a digital set-top box or other digital external device, refer to the figure as shown
below.
Component Connection
. How to connect
2. How to use
Turn on the digital set-top box.
(Refer to the owner’s manual for the digital set-top box
operation)
Select the Component 1 input source on the TV using the
INPUT button on the remote control.
If connected to COMPONENT IN2 input, select the
Component 2 input source on the TV.
Connect the video outputs (Y, PB, PR) of the digital set
top box to the COMPONENT IN VIDEO 1 jacks on
the set. Match the jack colors (Y = green, P
B = blue,
and PR = red).
Connect the audio output of the digital set-top box to
the COMPONENT IN AUDIO 1 jacks on the TV.
Supported Resolutions Y, CB/PB, CR/PR
Signal Component 1/2 HDMI1/2
480i Yes No
480p Yes Yes
720p Yes Yes
1080i Yes Yes
1080p Yes Yes
Resolution
Horizontal
Frequency (KHz)
Vertical
Frequency (Hz)
720x480i
15 . 73
15 . 73
59.94
60.00
720x480p
31 . 4 7
31 . 50
59.94
60.00
1280x720p
44.96
45.00
59.94
60.00
1920x1080i
33.72
33.75
59.94
60.00
1920x1080p
26.97
27.00
33.71
33.75
67.432
67.50
23.976
24.00
29.97
30.00
59.94
60.00
Zenith.book Page 16 Wednesday, April 2, 2008 11:46 AM
To Next Page
Loading...
