2.4 THERMOSTAT
Figura 34 Thermostat.
When function Thermostat from the “GENERAL” screen is enabled, the integrator will
be shown an additional tab, for the parameterisation of this functionality.
In said tab, a set of screens (Configuration, Setpoint, etc.) is provided to define the type
of the thermostatic control the user will be performing from Flat / Flat 55.
For further information about the behaviour and the parameterisation of the Zennio
“Building” thermostat implemented by Flat / Flat 55, please refer to the specific
documentation (“Zennio Thermostat”) available at (www.zennio.com).
To Next Page
Loading...
