2.1.2 TEMPERATURE SENSOR
Flat is equipped with one internal temperature probe which can monitor the ambient
temperature of the room, thus making the device capable of reporting it to the KNX bus
and of triggering certain actions when the temperature reaches specific values.
Please refer to the specific manual “Temperature Probe” (available in the Flat product
section at the Zennio homepage, www.zennio.com) for detailed information about the
functionality and the configuration of the related parameters.
Note: as previously specified, this functionality is only available for the Flat family
models and not for the Flat 55 models.
2.1.3 BACKLIGHT
Flat / Flat 55 allow managing the brightness of the LED according to two operating
modes: normal mode and night mode.
Please refer to the specific manual “Brightness” (available in the Flat / Flat 55 product
section at the Zennio website, www.zennio.com) for detailed information about the
functionality and the configuration of the related parameters.
2.1.4 SOUNDS
It is possible to configure Flat / Flat 55 so that a brief beep is emitted as an acoustic
feedback when a button is pressed.
Enabling the button sounds can be done either by parameters or through an object,
being also possible to define in parameters if the button sounds should be initially
enabled or not.
Moreover, Flat / Flat 55 can also emit the following sounds on request (through the
corresponding communication objects) if enabled:
Doorbell sounds: a single beep.
Alarm sounds: a sequence of brief beeps with a higher pitch. The sequence
will only stop when the alarm object gets deactivated or when the user
touches any of the buttons (this, moreover the deactivation alarm, will trigger
the button action).
The range of sounds emitted will be different depending on the sound type selected.
To Next Page
Loading...
