Zetor CRYSTAL HD 170 - Activation of the rear PTO shaft - independent revolutions - stationary working mode

Activation of the rear PTO shaft - independent revolutions - common working mode
FHD18N048
PTO shaft revolutions speed is dependent on engine revolutions.
With the engine running while the rear PTO shaft clutch disengaged:
A - Select the appropriate operating mode by the PTO shaft speed selector lever.
B - Select the appropriate speed using the rear PTO shaft speed selector button.
C - Pressing the rear PTO shaft switch button for at least one second puts the rear PTO shaft into operation.
When pressing the button the operator must sit on the driver's seat.
D - Rotation of the rear PTO shaft is indicated by the number of revolutions on the dashboard.
To interrupt the torque transmitted by the rear PTO shaft, press the button again.
If the rear PTO shaft is active and the operator leaves the driver's seat for more than five
seconds, an audio signal is generated and the rear PTO shaft is deactivated. Reactivation is
p
erformed when the operator sits on the driver's seat b
y
pressin
g
the button on the right column of
the cabin
.
DRIVE OF AGRICULTURAL MACHINERY
138