Safety principles of working with the three-point hitc
Height adjustment of the lifting draw-bars
Fixed and free position of the lower hydraulic draw-bars
Limiting draw-bars
Persons that are not authorized to work with
the attached implement must not stand between the
tractor and the hitched machine (implement) - (A). Do
not park the tractor with an attached implement in the
lifted position (B). During a drive without an
implement the lower draw-bars (5) must be connected
with springs and the upper draw-bar (1) must be
inserted into the spring suspension! During transport
of implements the limiting draw-bars (4) of the lower
draw-bars must be adjusted in such a way to avoid
unwanted lateral movement of the implement!
F11N032
Extend the capstan (1) in the arrow direction and make
the adjustment by turning the capstan.
C18N125
Fixed position of the lower hydraulic draw-bars (A):
The pin head (1) and washer (2) are installed horizontally.
Free position of the lower hydraulic draw-bars (B):
The pin head (1) and washer (2) are installed vertically.
The free position enables free connection of the tractor
and implement. In this case both the draw-bar ends may
move freely against each other as regards their height.
E454
The limiting draw-bars - stabilizers (1) limit or completely
prevent lateral swinging of the lower draw-bars. The
adjustment of the left and right limiting draw-bar is
performed by turning of the draw-bar pipe, see arrow.
Both the limiting draw-bars must always be
installed on the tractor.
C18N126
To Next Page
Loading...
