Replacing full-continuous motor oil filte
C15N079
1 - Cover
2 - Sealing ring
3 - Jacket
4 - Guide
5 - Filter element
6 - Clamp
Procedure for filter element replacement
Release the cover (1) by 2 to 3 revolutions and wait ca. 30 seconds.
Unscrew the cover (1) in anticlockwise direction.
Carefully release the filter body from the guide (4) in the jacket (5) in the upward direction.Catch the leaking
oil in a suitable vessel.
Slightly bend the filter element (5) in the retaining vessel to the side until the element is released from the
clamp (6).
Clean the components.
Replace the sealing ring (2) and oil it slightly.
Press the new filter element (5) into the clamp (6) and carefully put them together in the guide (4).
Firmly screw the cover (1) (25 Nm) in clockwise direction.
Check the ti
htness when the en
ine is runnin
The full flow oil filter is located in the right side of the
engine and is accessible when the engine bonnet is open
and the right bonnet sidewall is disassembled. The
replacement of the filter element is performed after each
oil change in the engine.
The replacement is performed when the engine is not
running.
C15N080
To Next Page
Loading...
