Windshield washer tank
Washer nozzle
Fluid reservoir for front axle brake control
TITAN ZH LHM PLUS is not compatible with synthetic hydraulic fluids and therefore must not
be mixed with them.
Under no circumstances TITAN ZH LHM PLUS should be mixed with brake fluids of DOT type!
Windshield washer tank is placed on the rear wall of the
cabin from the outside side.
The washer tank capacity is 2 litres.
In summer the reservoir should be filled with distilled wate
or mixture for washers.
Antifreeze mixture for washers must be used in winter
season for filling the washer tank.
C18N041
The washer nozzle is situated in the upper part of the
hood and is adjustable by needle or steel wire of
maximum diameter 0,8 mm.
C18N042
Check the front axle brake fluid tightness and the amount
of fluid in the leveling container.
The front brake control fluid reservoir is located on the
right side of the engine.
Keep the liquid level within 3/4 of the container content
(max. level) to 1/2 of the container content (minimum fluid
level).
The TITAN ZH LHM PLUS hydraulic oil is used as a fluid
in the hydraulic system of the front axle brake control.
C18N011
PREVENTIVE DAILY MAINTENANCE
To Next Page
Loading...
