Dry air cleaner maintenance instructions
Maintenance of the dry air cleaner includes the following activities:
1. Inspection of suction line (joint tightness, hose damage)
2. Checking the main filter cartridge (clogging, damage)
3. Checking the securing filter cartridge
Replace damaged parts
Air cleaner disassembly
Recovery of the mainair cleaner element
Replacing the safety element of the air cleaner
Disassemble the air cleaner according to the following
1. lift the front hood
2. release the air cleaner cover clips (indicated by arrows)
3. remove the cover of the cleaner (1)
C15N086
Remove the main element of the dry cleaner (2) by
pulling. If the main element is not damaged (there must
not be any dust on the inner side of the element), recover
it by blowing pressurized air from the inner side of the
element. This way you can recover the main element
3 times at the most. The element must be replaced once
a year.
NM14D015
- remove dry filter locking element (3) with a pull
Locking element cannot be regenerated. It must
be always replaced in these cases:
- when damaging main element
- after 5 maintenances of air filter
- at least once in two years
NM14D016
To Next Page
Loading...
