If you do not succeed in starting the engine
Immediately after start
When the engine is started, leave it idling without load for ca. 2 minutes.
During this time, perform checking of lubrication, charging, hydrostatic control (signal lamps must not be
illuminated) and other functions ensuring proper operation of the engine. The time of engine operation
without load must be adhered to, especially in winter period
Engine heating
C18N080
Do further heating of the engine during the drive. The heating of the engine by lengthy idle run
or sharp increase in revolutions is harmful to the engine. If the temperature of coolant has not
reached 45°C, do not exceed the engine revolutions over 2000 rpm.
Caution: If the air pressure in the tractor's air pressure system is less than 10 bar, the rear
wheels of the tractor are braked irrespective of the hand brake lever position and the tractor can not
be started until the air pressure in the tractor's air pressure system reaches at least 10 bar. When
attempting to start the tractor at low air pressure in the tractor's air pressure system, there is a risk
of damage to the clutch system.
Return the key to '0' position. Wait 60 second and repeat
the start.
Never help the stopping engine by a starter.
You are being exposed to the danger of starter
damage.
C18N079
To Next Page
Loading...
