Front three-point hitch - standard version of the tracto
FHD18N038
The front three-point hitch is controlled by the control (IV). In position (N), the front three-point hitch is
blocked against the drop.
Due to the leakage of the distributor, the front three-point hitch may fall.
Move the control (IV) from the (N) position towards the rear to raise the arms of the front three-point hitch. Do
not use the locked position at the end of the controller runway (B). Moving the control knob from the (N)
position towards the front triggers the front three-point hitch arms. After exceeding the increased resistance,
you can move the controller to the floating position (A) in which the actuator is locked.
The control of the front three-point hitch can be switched to the front three-point hitch control mode via the
oystick. Switching is done by switching on the switch (a), which is equipped with a lock against accidental
pressing.
Switching on the switch (a) is signaled by the backlight on the switch. Buttons at the top of the
o
stick are not operatin
. In the mode of controllin
the front thre
-point hitch with the joystick, the
controller (IV) is inoperative.
To Next Page
Loading...
