X-Ray Inspection System
User Manual
Page | 43 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
2) Image reading ability of the security inspectors is one of the skill assessments.
TIP operation procedure:
Figure 4-28 TIP Operation
Log in to the administrator account, set the TIP strategies and set the system in default
TIP assessment state. When the operator operates the equipment and finds any
dangerous articles, the operator must press the "Stop" button of the conveyor first and
press the "Mark" button on the special-purpose keyboard or the "P" button on the
common keyboard. Then the system will show successful marking and the operation
record will show the successful identification by the operator. If the operator fails to
inspect the inserted dangerous articles, it will show "You have ignored a TIP image"
immediately after passing the dangerous articles and this mistake will be recorded. TIP
system interface is shown in the following figure:
Figure 4-29 TIP Notice
To Next Page
Loading...
Need help?
General
