X-Ray Inspection System
User Manual
Page | 44 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
4.10.1 TIP Strategy
It can set the TIP basic information and the projection percent.
Basic information set in TIP: You can set the strategy name, priority level (1-10), start
time, end time, user role category, projection percent, dynamic judgement time and
static judgement time as shown in the following figure:
Figure 4-30 TIP Strategy
Strategy name: Set the strategy name according to the training records and query
needs.
Enable: It means the TIP mode can be enabled by selecting the check box. In addition,
the following settings can only be initiated when the TIP is in "ON" state.
Priority level: The administrator will set the priority levels (1-10 levels and 1st level is the
lowest level) for the newly built assessment items. Items with higher levels will be used
as a priority in assessment, if the priority conditions are not satisfied, the system will
initiate the low priority items.
User role category: Select the operators or administrators to receive the TIP training
based on different User role categories.
To Next Page
Loading...
Need help?
General
