X-Ray Inspection System
User Manual
Page | 54 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
5 Maintenance Instructions
The X-Ray security inspection system is a sophisticated mechanical and electrical product.
It is necessary to maintain the equipment on a daily basis apart from learning the
technical performance, software management and operational procedure of the
equipment. This chapter illustrates the tips and procedures for daily maintenance.
Installation Environment 5.1
1) The equipment should be installed in a ventilated, dustless and dry environment
and avoid high temperature, moisture and direct sunlight.
2) Clean the dust on the equipment by brush and vacuum before maintenance.
3) If the components or connectors are loose, tighten them immediately.
4) Do not let any material or liquid into the equipment during maintenance in order to
avoid electric leakage or accidents.
5) If the components get rusty or damaged, please contact our technician without
delay and do not dismantle the equipment by yourself.
Daily Cleaning 5.2
Note: Do not power on the equipment during cleaning.
5.2.1 Outer Surface of the Equipment
After operating for a long time, the outer surface of the equipment, control console,
display screen and other parts will be covered with all kinds of dust, stain and other dirt.
To guarantee the normal function of the equipment, the outer surface of the following
must be cleaned regularly.
1) Wipe the outer surface of the equipment with a wet towel.
To Next Page
Loading...
Need help?
General
