X-Ray Inspection System
User Manual
Page | 48 Copyright©2020 ZKTECO CO., LTD. All rights reserved.
Notes: If the customer initiates the TIP function, then all the operation results in training
demonstration will be recorded in the system. The system will get the statistical data on
a TIP quantity and the TIP data of all users. The administrator can check the relevant data
in TIP exam query.
4.11.3 Training Procedure
Step 1: Select the folder to choose the scanned parcel files required in training.
Step 2: Set the parameters (the save button is used to save the settings and backups).
Step 3: Click “Start” to start the training. The training box can be deleted but it will still
be shown in the menu bar (the icon means the training is going on).
Step 4: Click any operational key of the conveyor (in training mode, clicking any
operational key of the conveyor will not make the conveyor to move.) or image front-
pulling key, the interface center will show the training images when simulating the
operation of machine based on the parameter setting.
Step 5: When finding suspicious articles, press "Stop" button of the conveyor and the
"Mark" button on the special-purpose keyboard to mark the image.
Step 6: If you want to finish the training, click the “Pause”button of the conveyor to stop
the moving image and then click the menu or right-click the mouse to select "finish" to
finish the training.
System Settings 4.12
This function is accessible by the administrator, including: intelligent identification,
keyboard settings, counter settings and so on.
4.12.1 Intelligent Identification
You can set the "High density alert" and "Drugs and explosives inspection" in the
"intelligent identification" interface; the initiate mode and sensitivity can be set
separately (when checking " " to switch to initiate mode respectively, the alert box of
"High density alert" is red, the alert box of "Drugs and explosives inspection" is pink and
To Next Page
Loading...
Need help?
General
