Zodiac G2 - Page 17

SECTION 5 – PROBLEM SOLVING
PROBLEMS CHECKS SOLUTIONS
Your G2™ does not reach the
shallow end of the pool or moves
in a xed pattern.
Is the hose long enough?
Is the hose affected by the
return ow?
Are the hose lengths straight?
Add more sections of hose.
Adjust the return outlet towards
the bottom of the pool to make
sure that the jet of water does
not inuence the direction of the
G2™ hose.
Your G2™ climbs above the
water level.
Your G2™ does not climb the
walls easily.
Is there too much suction?
Is there sufcient suction?
Check that the Auto Weir Valve
is not blocked by leaves and
preventing the water from owing
through the Auto Weir Valve.
Adjust Auto Weir Valve setting
(Refer to correct settings page 5)
Make sure the lter is clean.
Adjust Auto Weir Valve setting
(Refer to correct setting page 5)
Your G2™ is sticking to corners or
at the steps.
Check the hose length (Refer
Section 1 page 3).
Return to your nearest pool store
for checking.
Remove Cassette unit from main
body and rinse both to ush
out debris.
Customer Care Helpline 0860 88 POOL (0860 887 665)
www.zodiac.co.za
14