Zodiac G2 - Assembling the Hose Protector; Positioning of the Hose Protector

SECTION 1 - INSTALLATION
STEP 4: Assembling the Hose Protector
1. Place the hose into one half of the Hose Protector.
2. Place the other half of the Hose Protector over the hose ensuring that the male clip line up with the female clip.
3. Apply pressure to both halves of the Hose Protector until both pieces clip into place.
STEP 5: Positioning of the Hose Protector
The ideal positioning to t the Hose Protector is directly after the hose cuff.
Note: If the hose is connected directly to the Automatic Weir Valve (not advised), position the Hose Protector
approximately 10cm from the hose cuff.
IMPORTANT: Please note that the Hose Protector must be tted to the section of the hose connected to the
90° Elbow or Automatic Weir Valve (i.e. furthest away from the APC).
To Automatic
Pool Cleaner
(APC)
Male hose cuff
Automatic Weir Valve
Insert into weir
90° Elbow
4