14
3.8 I The remote control (depending on the model)
• Respect the ba ery polarity.
• Do not recharge the ba ery, dismantle it or throw it onto a fi re.
• Do not expose it to high temperatures or direct sunlight.
3.8.1 Switching the remote control on and off
• To switch on: press .
• To switch off : press and hold
.
Tip: improve the remote control recep on.
The frequency of the fl ashing of the led located on the remote control indicates the recep on quality.
If the LED fl ashes quickly, recep on quality is OK.
For the best communica on between the control box and the remote control:
- Posi on the control box on the caddy.
- Turn the control box towards the pool
- Removal all large obstacles between the control box and the pool.
3.8.2 Direc ng the cleaner
• The remote control is equipped with movement sensors to direct the cleaner:
: Forward
: Backwards
: Le turn
: Right turn
: Stop
3.8 Taking the cleaner out of the water (depending on the model)
• Press . The cleaner moves toward the wall and climbs up to the waterline.
3.8.4 Synchronising the remote control with the control box
By default, the remote control is already synchronised with the control box. If replacing the remote control/control box
or if a synchronisa on problem occurs, follow the steps below:
• Place the remote control a maximum of 50 cm away from the control box.
• Connect the control box, check that the display shows the opera ng me, and that no cleaning cycle is running.
• Switch on the remote control by pressing
.
• Before the remote control switches to standby (around 45 seconds) press the
and bu ons simultaneously
for 6 seconds.
• Check that synchronisa on was successful by observing the display and the remote LED:
Display on the
control box
Remote LED
Result
Good
0:45
2 seconds
Flashing • Synchronisa on successful.
FAIL
On steady
• Check the distance between the control box and the remote
control is 50 cm maximum.
• Check the remote control ba eries. Replace them if necessary.
If the problem con nues contact your retailer.
EN
To Next Page
Loading...
Need help?
General
