Wireless-G PCI Card18
7
77
7
In the
Pre-shared key [WPA]
area, enter the same network
key that is used on the wireless access point. To achieve
adequate security, you should enter a key with a minimum of
20 random characters.
8
88
8
Click
OK
to save your settings and return to the
Configuration
tab.
9
99
9
On the
Configuration
tab, click
Apply
.
10
1010
10
Click the
Close
box to exit the configuration software.
That’s it! You have configured WPA-PSK security for your
wireless connection, and you’re ready to use the Internet.
WEP (Wired Equivalent
Privacy)
5
55
5
If you are joining an infrastructure network, make sure the
access point is configured for WEP.
Note
: If just one (or
more than one) device in the network uses WEP, all devices
must use it.
6
66
6
In the
Security Configuration
window, click the
Encryption
Mode
drop-down arrow and select
WEP
:
To Next Page
Loading...
General