Recording
Monitoring input sounds
Use headphones, for example, to monitor input sounds and adjust the volume.
1. Connect headphones, for example, to the PHONE/LINE OUT jack.
2. Use to adjust the volume.
The volume is shown on the display while the volume is being adjusted.
NOTE
• When nothing is connected to the PHONE/LINE OUT jack, operating will change the
speaker volume.
• The built-in speaker cannot be used for monitoring while recording.
• When “Volume Control” is set to “Fixed”, cannot be used to adjust the volume. To use
for volume adjustment, set “Volume Control” to “Knob”. (→ Making output settings)
HINT
When monitoring with headphones is unnecessary, disconnecting headphones from the PHONE/LINE OUT
jack can increase the amount of operation time when using batteries.
38
To Next Page
Loading...
