Conducting a full test
1. Press when the Home Screen is open.
This opens the Menu Screen.
2. Use / to select “SD Card” and press to confirm.
3. Use / to select “Full Test” and press to confirm.
The amount of time required for the full test will be shown.
4. Use / to select “Execute” and press to confirm.
The card performance test will start.
The result of the test will be shown when it completes.
If Access Rate Max. reaches
100％,
the card will fail (NG).
NOTE
Even if a performance test result is "Pass", there is no guarantee that writing errors will not occur. This
information is just to provide guidance.
92
To Next Page
Loading...
