Zoom H6essential - Page 57

5. Use to adjust the line out level and press .
The output level meters can be checked while adjusting.
HINT
• This can be set to “Mute” or from −40 to +40.
• Selecting “Mute” silences the output from the LINE OUT jack.
6. To output the test tone from the H6essential and adjust the output level, press .
While checking the audio level meter of the connected device, adjust the input gain of that device until
the audio signal level is about −6 dB.
HINT
The test tone is a 1kHz sine wave at −20 dBFS.
7. After adjusting the input gain of the connected device, press .
This stops test tone output.
NOTE
• See the manual of the connected device for information about its operation.
• If the automatic gain control function on the other device is on, turn it off.
• The level adjusted here does not affect the recorded audio or the audio levels output from the
headphone jack or the USB port.
57