Recording on the H6essential while using it as an audio
interface
As explained in “Connecting to computers, smartphones and tablets”, if the Mode is set to “Audio I/F + REC”
the H6essential can record while it is being used as an audio interface. In this case, recording settings can
be made in the same way as when using it as a recorder.
See the references below and make recording settings.
Reference Explanation
Capturing audio before recording
starts (pre-recording)
The input signal is always buffered for a set amount of time, so it
can be captured (pre-recorded) for up to 2 seconds before the time
when is operated to start recording.
Recording with levels adjusted on
the Mixer Screen
When recording, the levels of the sounds as input or the levels as
adjusted on the Mixer Screen can be used.
Enabling the recording start tone Half-second tone signals (recording start tones) can be output from
the output jacks (headphone and LINE OUT jacks) when recording
is started.
Writing metadata (iXML chunks) to
recording files
Various related information (metadata) stored in iXML chunks can
be written to recorded files.
NOTE
As explained in “Connecting to computers, smartphones and tablets”, when the mode is set to “Audio I/F
+ REC” the sample rate of the H6essential cannot be changed. To change the sample rate, disconnect the
computer, smartphone or tablet and follow the instructions in “Setting the sample rate ”.
HINT
Press to open the Playback Screen where recorded files can be played back. (→ Playing recordings)
95
To Next Page
Loading...
