Capturing audio before recording starts (pre-recording)
The input signal is always buffered for a set amount of time, so it can be captured (pre-recorded) for up to 2
seconds before the time when is operated to start recording.
This is useful when is operated late, for example.
1. On the Home Screen, use to select (Rec Settings) and press .
This opens the Rec Settings Screen.
2. Use to select “Pre Rec” and press to confirm.
3. Use to select “On” and press to confirm.
The amount of time that can be pre-recorded when this is set to “On” depends on the sample rate
setting (→ Setting the sample rate).
Sample Rate Pre-recording time
44.1 kHz 2 seconds
48 kHz 2 seconds
96 kHz 1 second
63
To Next Page
Loading...
