Zoom MultiStomp MS-50G - Firmware Update Process; Connecting and Executing Firmware Update

23
Updating the Firmware
Updating the Firmware
While pressing
both
1
To update the firmware
When the has f inis h ed up datin g,
”Complete!” appears on the display.
The FIRMWARE UPDATE
screen appears.
Disconnect the USB cable.
HINT
t 4FFUIF;00.XFCTJUF GPS JOTUSVDUJPOTBCPVUIPX
to use the application.
HINT
t Updating the firmware will not erase saved patch memories.
NOTE
t %POPUEJTDPOOFDUUIF64#DBCMFXIJMFUIFmSNXBSF
is being updated.
1. While pressing both the up and down cursor
keys, use a USB cable to connect the USB
connector to the computer.
2. Launch the firmware update application on
your computer, and execute the update.
3. Confirm that the firmware has been updated.