Zoom MultiStomp MS-50G User Manual

5
Part Names
Part Names
From the left
Parameter knob 1 [ ]
Turn left and right to adjust the parameter.
Press to open the MENU where you can remove and
rearrange effects and make various settings (
!
P12, 18).
You can also check the firmware version (
!
P22).
Parameter knob 2 [ ]
Turn left and right to adjust the parameter.
Press to open the MEMORY screen where you can
select and save patch memories, and change patch
memories using the footswitch (
!
P10, 11).
Parameter knob 3 [ ]
Turn left and right to adjust the parameter.
Press to change the parameter page (
!
P9).
Up and down cursor keys [ / ]
Press to change the effect type.
Press and hold for 1 second to select the effect category
(
!
P8).
Left and right cursor keys [ / ]
Press to show the effect to the left or right.
Press and hold for 1 second to add a new effect left or
right of the current effect (
!
P12).
Parameter knobs Cursor keys

Zoom MultiStomp MS-50G Specifications

General

Simultaneous Effects	6
Display	LCD
Sampling Frequency	44.1 kHz
A/D Conversion	24-bit
D/A Conversion	24-bit
Patches	50
Input	1/4"
Output	1/4"
Power	9V DC
Weight	350 g (without batteries)
Frequency Response	20Hz - 20kHz
Power Supply	Batteries: AA/LR6 battery x 2
Battery Life	Approx. 6 hours (alkaline batteries)
Effect Types	Delay, Reverb, Modulation, Distortion, EQ, Filter, Dynamics