Zoom MultiStomp MS-50G User Manual

9
Adjusting Effects
Adjusting Effects
4
To change the page
Press
The next page opens.
Effect processing limit
The a l l o w s yo u to
co m b i n e 6 effe ct s as you li k e.
However, i f y o u com b ine effect
types that require great amounts of
processing power (amp models, for
example), the available processing
capacity might not be enough. If the processing required for an
effect exceeds the available capacity, the effect is bypassed and
a ”DSP Full!” message appears. This can be avoided by changing
1 or more of the effect types or setting them to THRU.
NOTE
t "O FGGFDU SFRVJSFT UIF TBNF BNPVOU PG
processing power whether it is ON or OFF.
HINT
t 1SFTTBOEIPMEUIFCVUUPOGPS
at least 1 second to immediately set an effect
to THRU.

Zoom MultiStomp MS-50G Specifications

General

Simultaneous Effects	6
Display	LCD
Sampling Frequency	44.1 kHz
A/D Conversion	24-bit
D/A Conversion	24-bit
Patches	50
Input	1/4"
Output	1/4"
Power	9V DC
Weight	350 g (without batteries)
Frequency Response	20Hz - 20kHz
Power Supply	Batteries: AA/LR6 battery x 2
Battery Life	Approx. 6 hours (alkaline batteries)
Effect Types	Delay, Reverb, Modulation, Distortion, EQ, Filter, Dynamics