Zoom PFX-9003 User Manual

Using the ARRM Function
ZOOM PFX-9003
36
When page 1 of the ARRM module is selected, sliders 1 – 3 control the
following parameters.
3. Use slider 1 to select the control target from the following options.
• vL (volume)
The ARRM function controls the volume of the entire patch.
• GA (gain)
The ARRM function controls the GAIN parameter (for some effect types
the TOP parameter) of the DRIVE module. This means that the distortion
intensity changes.
• Md (modulation)
The ARRM function controls the effect type currently selected in the MOD
module. The actual parameter that changes depends on the effect type.
• rv (reverb)
The ARRM function controls the effect type currently selected in the REV
module. The actual parameter that changes depends on the effect type.
4. If "vL" has been selected as control target, adjust the MINVOL
parameter value with slider 2, as required.
ASSIGN
Slider 1
Slider 3
Slider 2
ASSIGN parameter (control target)
MODE parameter (direction and range of change
at control target)
MINVOL parameter (valid volume setting when control
target is volume and MODE parameter is Hi or Lo)

Zoom PFX-9003 Specifications

General

Brand	Zoom
Model	PFX-9003
Category	Recording Equipment
Language	English