Zoom PFX-9003 - TOTAL Module; ARRM Module

Effect Types and Parameters
ZOOM PFX-9003
49
◆ ARRM module
Varies parameters cyclically according to the control waveform from an internal generator.
Parameter 1: ASSIGN Parameter 2: MINVOL Parameter 3: MODE
Parameter 4: WAVE Parameter 5: SYNC
Parameter description
Parameter name Setting range Explanation
ASSIGN vL, GA, Md, rv
Selects the control target module. (See table 6.)
MINVOL 0 – 10
Sets the minimum volume when the ASSIGN
parameter is set to VOL.
MODE UP, dn, Hi, Lo
Selects the change type and width.
WAVE 1 – 8
Selects the control waveform type.
SYNC 0.5 – 3, b1 – b4
Adjusts the control waveform cycle (See table 7.)
Table 6: ASSIGN
Setting Control target Setting Control target
vL
Patch volume
Md
MOD module parameter
GA
GAIN parameter of DRIVE module
rv
REV module parameter
Table 7: SYNC
Setting Cycle Setting Cycle
5
Eighth note
b1
1 measure
1
Quarter note
b2
2 measures
2
Half note
b3
3 measures
3
Dotted half note
b4
4 measures
◆ TOTAL module
Comprises overall patch settings.
Parameter 1: PATLVL Parameter 4: Patch name (A-Z) Parameter 5: Patch name (0-9)
Parameter 6: Patch name (symbols)
Parameter description
Parameter name Setting range Explanation
PATLVL
1 – 30
Adjusts the patch volume level. A setting
of 25 results in equal input signal and
output signal level.
Patch name (A-Z)
A – Z
Enters alphabet characters.
Patch name (0-9)
0 – 9
Enters numerals.
Patch name (symbols)
+ - @ (space)
Enters symbols.