Zoom V3 User Manual

13
Adjusting the reverb
Adding reverberations gives the sound width and depth.
1.
Turn .
Turn it right to increase the effect. Turn it completely left to turn the reverb effect off.
Using audio interface functions
■
Installing the driver
Windows
1.
Download the ZOOM V3 Driver from www.zoom.co.jp to the computer.
The latest ZOOM V3 Driver can be downloaded from the above website.
Download the driver for the operating system being used.
2.
Launch the installer and follow the instructions to install the ZOOM V3 Driver.
See the Installation Guide included in the driver package for detailed installation procedures.
If the power supplied by the USB bus is low, or you want to operate the unit with an adapter, use
the dedicated AC adapter (ZOOM AD-16).
Mac computers and iOS/iPadOS devices
A driver is not necessary when using a Mac or iOS/iPadOS device.
■
Connecting to a computer or iOS/iPadOS device
1.
Use a USB cable to connect the
V3
with the computer or iOS/iPadOS device.
NOTE
When connecting to an iOS/iPadOS
device, use a Lightning to USB camera
adapter (or Lightning to USB 3 camera
adapter).
2.
Set to ON.
Turn the
V3
on and connect the iOS/iPadOS device.
If connecting to a computer, continue with step 3.
3.
When connecting a computer, set the
V3
as the sound device.

Zoom V3 Specifications

Power

AC adapter voltage	9V DC
AC adapter current	500 mA
phantom power	+48 V
battery type	4 AA batteries
battery life	3.5 hours

Inputs and Outputs

MIC IN input gain	+3 – 40 dB
MIC IN maximum input level	+4 dBu
MIC IN input impedance	3 kΩ or more
AUX IN rated input level	−10 dBu
AUX IN input impedance	22 kΩ
L/R output maximum level	+6 dBu
L/R output impedance	100 Ω
PHONES maximum output	20 mW + 20 mW (into 32 Ω load)

Audio Specifications

sampling frequency	44.1 kHz
A/D conversion	24-bit 128× oversampling
D/A conversion	24-bit 128× oversampling
signal processing	32-bit
frequency response	20 Hz – 20 kHz (+1 dB/−3 dB)

Weight and Dimensions

weight	0.59 kg
depth	150 mm
width	190 mm
height	50 mm