Configuration
2 - 30 Network T8 Control Unit – Version 2.0 02060220.fm 11.12.07/Ch,Kx
Typical application 1: simplest configuration
1. Create data exchange directory
On the GISPC:
• Create the data exchange directory for the machine:
typically C:\ZSK \MUSTER
2. Enable data exchange directory for network operation
On the GISPC:
• Set up the access rights for the directory to full access, i.e. write and read ac-
cess rights.
• If a user account has been set up as described in section 2.1 Necessary operat-
ing system settings (Windows) (Net User), grant access authorization for
this account. Alternatively, if a guest account is used, leave the access autho-
rization setting on Everyone.
• Use the following share name:
D For the machine enable the directory C:\ZSK under the share name:
FRZSK
3. Set up the access path for the BasePac software to the data
exchange directory
On the GISPC:
• In the BasePac software, set up the access path to the ZSK memory of ma-
chine: C:\ZSK \MUSTER
4. Set up network connection at T8 control unit.
On the machine's T8 control unit:
• Set up the network connection for the machine to \\GISPC \FRZSK.
To Next Page
Loading...
