Zte WARP 7 - Mobile Network Settings

Settings 234
● Pairing Bluetooth Devices: Make sure the other devices are set to be discovered. From
Bluetooth settings, tap the device name in ―Available devices‖ and follow the onscreen
instructions.
 Depending on the device, you may be required to enter or accept a passkey.
 If the target device does not appear, tap Menu > Refresh to search again.
 This setting is available when Bluetooth is enabled.
● Change the Name of a Paired Device: From Bluetooth settings, tap Settings next to a
paired device name, tap the current name, enter a new name, and tap OK.
 Emoji cannot be used in a device name.
 This setting is available when Bluetooth is enabled.
● Canceling Pairing: From Bluetooth settings, tap Settings next to a paired device name, and
then tap Forget.
 This setting is available when Bluetooth is enabled.
● Enable Service from Paired Device: From Bluetooth settings, tap Settings next to a paired
device name, and then tap the listing under Use for.
 If a confirmation prompt appears, follow the onscreen instructions.
 This setting is available when Bluetooth is enabled.
 This setting is available when the paired device is providing a service.
● Search for Other Devices: From Bluetooth settings, tap Menu > Refresh.
 This setting is available when Bluetooth is enabled.
● Check Files Received via Bluetooth Transfer: From Bluetooth settings, tap Menu > Show
received files, and follow the onscreen instructions.
Mobile Network Settings
The Mobile networks options let you enable your phone's mobile data access and set your preferred
network mode.