Zte WARP 7 - For Assistance; Troubleshooting

For Assistance 280
For Assistance
The following topics address areas of support for your phone, including troubleshooting, specifications,
account information, warranty information, and customer service contact information.
Troubleshooting
Check the problems and solutions below for troubleshooting solutions for common phone issues.
Check Here First
Problem: Phone freezes/operation is unstable.
Solution: Turn the phone on again. If you are unable to turn the phone off, remove and replace the
battery, and then turn the phone on again. Data that was being edited is erased after your phone is
powered on again.
Problem: Operation is unstable after a new application was installed.
Solution: The newly installed application may be the cause. Uninstall the application in Safe mode.
See Uninstall an App. To turn the phone on in Safe mode:
 Press and hold the Power/Lock key > touch and hold Power off, read the disclaimer for safe
mode, and then tap OK.
• After turning the phone on in Safe mode, "Safe Mode" appears at lower left.
• After restarting in Safe mode, your phone can be powered on as usual.
• Before turning the phone on in Safe mode, it is recommended that you back up important
data.
• By powering the phone on in Safe mode, added widgets may not be displayed.
Problem: Cannot use phone, mail, or Internet.
Solution 1: Check whether you are where signal is weak or out of service area.
Solution 2: Power the phone on again.
Solution 3: Is the phone in Airplane mode? To check that Airplane mode is canceled:
 From home, tap Apps > Settings > More and touch the Airplane mode slider.
Solution 4: Is data communication disabled? To check that data communication is enabled:
 From home, tap Apps > Settings > Mobile networks and touch the Data Enabled
slider.