Zte ZXR10 T600

ZXR10T600/T1200UserManual(IPv6Volume)
St-
ep
CommandFunction
Thedefaultvalueforpoint
topointandbroadcast
interfacesis40seconds.
Thedefaultvaluefor
non—broadcastand
point-to-multipointinterfaces
is120seconds.
ZXR10(config-if)#ipv6ospfcost<cost-value>[insta
nce<0–255>]
Thissetstheinterfacecost
value.
Theunitissecond.Therange
isfrom1to65535.
Thedefaultvalueofloopback
interfaceis1,andother
interfacesis10.
ZXR10(config-if)#ipv6ospfpriority<value>[insta
nce<0–255>]
Thissetstheinterface
priority.
Therangeisfrom0to255.
Thedefaultvalueis1.
Result:Theinterfaceattributeshavebeencongured.
ConfiguringOSPFv3Protocol
Attributes
Tocongureprotocolattributes,performthefollowingsteps.
St-
ep
CommandFunction
1
ZXR10(config)#ipv6routerospf<process-id>
ThisenablesanOSPFv3
instanceandentersOSPFv3
congurationmode.
2
ZXR10(config-router)#area<area-id>default-cost
<cost-value>
Thisconguresthedefault
metricvalueforanarea.
3
ZXR10(config-router)#area<area-id>range
X:X::X:X/<0-128>[advertise|not-advertise]
Thiscongurestherangeof
summaryaddressinanarea.
4
ZXR10(config-router)#area<area-id>stub
[no-summary]
Thisdenesanareaasthe
stubarea.
no-summaryimpliesABRis
forbiddentosendsummary
routetothisstubarea.
5
ZXR10(config-router)##area<area-id>virtual-link
<router-id>[hello-interval<seconds>][retra
nsmit-interval<seconds>][transmit-delay
<seconds>][dead-interval<seconds>]
ThisdenesanOSPFvirtual
link.
38CondentialandProprietaryInformationofZTECORPORATION