ZyXEL Communications DX3301-T0 - 7.3 The Parental Control Screen

Chapter 7 Connection Status
AX/DX/EX/PX Series User’s Guide
142
Each field is described in the following table.
7.3 The Parental Control Screen
Use this screen to view the number of profiles that were created for parental control.
Figure 78 Parental Control
Click the yellow Arrow icon to open the following screen. Use this screen to enable parental control and
add more profiles. Add a profile to create restricted access schedules. Go to the Security > Parental
Control > Add New PCP/Edit screen to configure URL filtering settings to block the users on your network
from accessing certain web sites.
Table 27 LAN Setup
LABEL DESCRIPTION
LAN IP Setup
IP Address Enter the LAN IPv4 IP address you want to assign to your Zyxel Device in dotted decimal
notation, for example, 192.168.1.1 (factory default).
Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example 255.255.255.0
(factory default). Your Zyxel Device automatically computes the subnet mask based on the
IP Address you enter, so do not change this field unless you are instructed to do so.
IP Addressing Values
Beginning IP
Address
This field specifies the first of the contiguous addresses in the IP address pool.
Ending IP
Address
This field specifies the last of the contiguous addresses in the IP address pool.
DHCP Server State
DHCP Server
Lease Time
This is the period of time a DHCP-assigned address is valid, before it expires.
When a client connects to the Zyxel Device, DHCP automatically assigns the client an IP
addresses from the IP address pool. DHCP leases each addresses for a limited period of time,
which means that past addresses are “recycled” and made available for future
reassignment to other devices.
Days/Hours/
Minutes
Enter the lease time of the DHCP server.
Save Click Save to save your changes.