Chapter 36 User Account
AX/DX/EX/PX Series User’s Guide
385
36.2.1 User Account Add or Edit
Add or change the name of the user account, set the security password and the retry times, and
whether this user will have Administrator or User privileges.
Click Add New Account or the Edit icon of an
existing account in the Maintenance > User Account to open the following screen.
Figure 242 Maintenance > User Account > User Account Add
The following table describes the labels in this screen.
Group This field displays whether this user has Administrator or User privileges.
Remote
Privilege
This field displays whether this user can access the Zyxel Device with HTTP, Telnet or SSH through
the WAN, LAN or LAN/WAN.
Modify Click the Edit icon to configure the entry.
Click the Delete icon to remove the entry.
Cancel Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
Table 154 Maintenance > User Account (continued)
LABEL DESCRIPTION
Table 155 Maintenance > User Account > User Account Add
LABEL DESCRIPTION
Active Click to enable (switch turns blue) or disable (switch turns gray) to activate or deactivate the
user account.
User Name Enter a new name for the account (up to 15 characters). Special characters are allowed except
the following: double quote (") back quote (`) apostrophe or single quote (') less than (<) greater
than (>) caret or circumflex accent (^) dollar sign ($) vertical bar (|) ampersand (&) semicolon
(;)
Password Type your new system password (up to 256 characters). Note that as you type a password, the
screen displays a (*) for each character you type. After you change the password, use the new
password to access the Zyxel Device.
To Next Page
Loading...
