Chapter 44 Diagnostic
AX/DX/EX/PX Series User’s Guide
411
44.3 Ping/TraceRoute/Nslookup Test/ Speed Test
Use this screen to ping, traceroute, nslookup, or speed test for troubleshooting. Ping and traceroute are
used to test whether a particular host is reachable. After entering an IP address and clicking one of the
buttons to start a test, the results will be shown in the Ping/Traceroute Test area. Use nslookup to find the
IP address for a host name and vice versa. Use speed test to determine the download and upload
speed.
Note: Not all Zyxel Devices support speed test; see Chapter 1 on page 62 for more
information.
Click Maintenance > Diagnostic to open the following screen.
Figure 263 Maintenance > Diagnostic
The following table describes the fields n this screen.
Table 166 Maintenance > Diagnostic
LABEL DESCRIPTION
Ping/TraceRoute Test The result of tests is shown here in the info area.
Diagnostic Test The result of tests is shown here in the info area.
TCP/IP
Address
Type the IP address of a computer that you want to perform ping, traceroute, or nslookup in
order to test a connection.
Ping Click this button to perform a ping test on the IPv4 address or host name in order to test a
connection. The ping statistics will show in the info area.
Ping 6 Click this button to perform a ping test on the IPv6 address or host name in order to test a
connection. The ping statistics will show in the info area.
To Next Page
Loading...
