Chapter 9 Wireless
AX/DX/EX/PX Series User’s Guide
206
9.10.6 MBSSID
Traditionally, you need to use different APs to configure different Basic Service Sets (BSSs). As well as the
cost of buying extra APs, there is also the possibility of channel interference. The Zyxel Device’s MBSSID
(Multiple Basic Service Set IDentifier) function allows you to use one access point to provide several BSSs
simultaneously. You can then assign varying QoS priorities and/or security modes to different SSIDs.
Wireless devices can use different BSSIDs to associate with the same AP.
9.10.6.1 Notes on Multiple BSSs
• A maximum of eight BSSs are allowed on one AP simultaneously.
• You must use different keys for different BSSs. If two wireless devices have different BSSIDs (they are in
different BSSs), but have the same keys, they may hear each other’s communications (but not
communicate with each other).
• MBSSID should not replace but rather be used in conjunction with 802.1x security.
9.10.7 Preamble Type
Preamble is used to signal that data is coming to the receiver. Short and long refer to the length of the
synchronization field in a packet.
Short preamble increases performance as less time sending preamble means more time for sending
data. All IEEE 802.11 compliant wireless adapters support long preamble, but not all support short
preamble.
Use long preamble if you are unsure what preamble mode other WiFi devices on the network support,
and to provide more reliable communications in busy WiFi networks.
Use short preamble if you are sure all WiFi devices on the network support it, and to provide more
efficient communications.
Use the dynamic setting to automatically use short preamble when all WiFi devices on the network
support it, otherwise the Zyxel Device uses long preamble.
Note: The WiFi devices MUST use the same preamble mode in order to communicate.
9.10.8 WiFi Protected Setup (WPS)
Your Zyxel Device supports WiFi Protected Setup (WPS), which is an easy way to set up a secure WiFi
network. WPS is an industry standard specification, defined by the WiFi Alliance.
WPS allows you to quickly set up a WiFi network with strong security, without having to configure security
settings manually. Each WPS connection works between two devices. Both devices must support WPS
(check each device’s documentation to make sure).
Depending on the devices you have, you can either press a button (on the device itself, or in its
configuration utility) or enter a PIN (a unique Personal Identification Number that allows one device to
authenticate the other) in each of the two devices. When WPS is activated on a device, it has 2 minutes
to find another device that also has WPS activated. Then, the two devices connect and set up a secure
network by themselves.
To Next Page
Loading...
