Chapter 2 Hardware
AX/DX/EX/PX Series User’s Guide
54
Note: Make sure the transceiver’s latch is pushed all the way down, so the transceiver can be
pulled out successfully.
4 Pull the latch, or use your thumb and index finger to grasp the tabs on both sides of the transceiver, and
carefully slide it out of the slot.
Note: Do NOT pull the transceiver out by force. You could damage it. If the transceiver will not
slide out, grasp the tabs on both sides of the transceiver with a slight up or down motion
and carefully slide it out of the slot. If unsuccessful, contact Zyxel Support to prevent
damage to your Zyxel Device and transceiver.
5 Insert the dust plug into the ports on the transceiver and the cables.
Figure 37 Removing the Fiber Cables
Figure 38 Opening the Transceiver’s Latch Example
Figure 39 Transceiver Removal Example
2.3.4 WPS Button
You can use the WPS button to quickly set up a secure wireless connection between the Zyxel Device
and a WPS-compatible client by adding one device at a time.
To activate WPS:
1 Make sure the POWER LED is on and not blinking.
2 Press the WPS button for at least 1 or 5 seconds (see the following table) and release it.
To Next Page
Loading...
