Chapter 2 Hardware
AX/DX/EX/PX Series User’s Guide
55
3 Press the WPS button on another WPS-enabled device within range of the Zyxel Device (within 120
seconds). The WIFI 2.4G / WIFI 5G LED flashes amber while the Zyxel Device sets up a WPS connection
with the other wireless device.
4 Once the connection is successfully made, the WIFI 2.4G / WIFI 5G LED will light green.
2.3.5 RESET Button
If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button to reload the factory-default configuration file. This means that you will lose all configurations
that you had previously. The password will be reset to the factory default (see the device label), and the
LAN IP address will be “192.168.1.1”.
1 Make sure the POWER LED is on (not blinking).
2 To set the device back to the factory default settings, press the RESET button for more than 5 seconds or
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the defaults
have been restored and the device restarts.
Table 14 WPS Button Press Duration
MODELS
PRESS
DURATION
EX5501-B0 1 second
AX7501-B0, DX3300-T0, DX3301-T0,
DX5301-B2/B3, DX5401-B0, EX3300-T0/
EX2210-T0, EX3301-T0, EX5300-B3,
EX5301-B3, EX5401-B0, EX5600-T1,
EX5601-T0, EX5601-T1 and PX7501-B0
5 second
To Next Page
Loading...
