Chapter 8 Broadband
AX/DX/EX/PX Series User’s Guide
157
Bridge Mode
Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon next to the
connection you want to configure. The following example screen displays when you select Bridge
mode.
Figure 88 Network Setting > Broadband > Add or Edit New WAN Interface (Bridge Mode)
Maximum Burst
Size [cells]
Maximum Burst Size (MBS) refers to the maximum number of cells that can be sent at the peak
rate. Type the MBS, which is less than 65535.
MAC Address Enter the MAC address you want to use.
DHCPv6 Option (This is available only when you select IPv6 Only or IPv4 IPv6 DualStack in the IPv4/IPv6 Mode field.)
IPv6 Address
From DHCPv6
Server
Click the switch (to the right) to let the Zyxel Device send DHCP requests to the DHCPv6 server to
obtain an IPv6 address.
Other
Information
From DHCPv6
Server
Click the switch (to the right) to have the Zyxel Device get other information, such as DNS
information, from DHCPv6 packets sent from the DHCPv6 server.
This will be enabled if IPv6 Address From DHCPv6 Server is enabled.
Cancel Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
Table 34 Network Setting > Broadband > Add or Edit New WAN Interface (Routing Mode) (continued)
LABEL DESCRIPTION
To Next Page
Loading...
