Chapter 8 Broadband
AX/DX/EX/PX Series User’s Guide
166
Bridge Mode
Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon next to the
connection you want to configure. The following example screen displays when you select Bridge
mode.
DS-Lite
This is available only when you select IPv6 Only in the IPv4/IPv6 Mode field. Enable Dual Stack
Lite to let local computers use IPv4 through an ISP’s IPv6 network. See Dual Stack Lite on page
149 for more information.
Click this switch to let local computers use IPv4 through an ISP’s IPv6 network. When the switch
goes to the right , the function is enabled. Otherwise, it is not.
DS-Lite Relay
Server IP
Specify the transition router’s IPv6 address.
6RD The 6RD (IPv6 rapid deployment) fields display when you set the IPv6/IPv4 Mode field to IPv4
Only. See IPv6 Rapid Deployment on page 149 for more information.
Click this switch to tunnel IPv6 traffic from the local network through the ISP’s IPv4 network. When
the switch goes to the right , the function is enabled. Otherwise, it is not.
Select Manually Configured if you have the IPv4 address of the relay server. Otherwise, select
Automatically configured by DHCPC to have the Zyxel Device detect it automatically through
DHCP.
The Automatically configured by DHCPC option is configurable only when you set the method of
encapsulation to IPoE.
Service Provider
IPv6 Prefix
Enter an IPv6 prefix for tunneling IPv6 traffic to the ISP’s border relay router and connecting to the
native IPv6 Internet.
IPv4 Mask
Length
Enter the subnet mask number (1 – 32) for the IPv4 network.
Border Relay
IPv4 Address
When you select Manually Configured, specify the relay server’s IPv4 address in this field.
DHCPv6 Option (This is available only when you select IPv6 Only or IPv4 IPv6 DualStack in the IPv4/IPv6 Mode field.)
IPv6 Address
From DHCPv6
Server
Click the switch (to the right) to let the Zyxel Device send DHCP requests to the DHCPv6 server to
obtain an IPv6 address.
Other
Information
From DHCPv6
Server
Click the switch (to the right) to have the Zyxel Device get other information, such as DNS
information, from DHCPv6 packets sent from the DHCPv6 server.
This will be enabled if IPv6 Address From DHCPv6 Server is enabled.
Cancel Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
Table 37 Network Setting > Broadband > Add or Edit New WAN Interface (Routing Mode) (continued)
LABEL DESCRIPTION
To Next Page
Loading...
